Tools: Tevo Tornado: Difference between revisions

Revision as of 01:30, 26 October 2022

Tevo Tornado 3D Printer with BLTOUCH and Wham Bam Pex build plate.

marlin 2.0.x bugfix at 164199614c4614144d4b4abc455adc6393d9167a dated Sat Jan 30 07:07:35 2021 +0100.

Firmware is not on a tagged release along the 2.0.x bugfix branch.

http://10.255.0.135 OctoPi 0.18.0 with OctoPrint 1.8.4 running on a Raspberry Pi 4 Model B Rev 1.2 2GB RAM

Plugins:

@@ Line 5: / Line 5: @@
 == Issues ==
-OctoPrint issues <code>M155 S2</code>, but printer does not report temperatures. See [https://marlinfw.org/docs/gcode/M155.html https://marlinfw.org/docs/gcode/M155.html]. The firmware is built with AUTO_REPORT_TEMPERATURES and EXTENDED_CAPABILITIES_REPORT. To back that up, the printer responds to <code>M115</code> with <code>Cap:AUTOREPORT_TEMP:1</code>. Without repeated temperature reports, OctoPrint times out the connection with the printer. Building the firmware with periodic <code>#define NO_TIMEOUTS 1000</code> causes the printer keep the connection alive with <code>wait</code> responses.
+Firmware is not on a tagged release along the 2.0.x bugfix branch.
-The BAUDRATE was set to 115200 during debugging, but can likely go back to 250000.
 == OctoPrint ==