Tools: Hypercube 300: Difference between revisions
Jump to navigation
Jump to search
Added Last revision. |
Initial writeup; problem#1; This sucks |
||
| Line 1: | Line 1: | ||
Last revision {{REVISIONTIMESTAMP}} by {{REVISIONUSER}} | Last revision {{REVISIONTIMESTAMP}} by {{REVISIONUSER}} | ||
== Accessing the Hypercube == | |||
* From within the Tampa Hackerspace network, the Hypercube #1 can be accessed by browsing to _____________ | |||
* Remotely, printer status can be viewed by logging in to THS's Slack and viewing the #3d_printer_status channel. | |||
== Building the Hypercube == | |||
Hypercube 300....and it uses CoreXY motion mechanics. | Hypercube 300....and it uses CoreXY motion mechanics. | ||
== Problems we've encountered == | |||
=== Hypercube bed is all the way down and does not want to move === | |||
Resolution by @adrianm1972: | |||
* The Z motors were a little out of alignment with the z lead screw nuts on the best. It ran fine at the top of its range because the lead screws are unsupported up there and that masks the alignment problem. At the bottom of its movement range everything is bolted to the frame and the slight misalignment cause binding that the Z stepper motors could not overcome. | |||
* We brought the bed all the way down, loosened the Z motor mounts and let everything pull itself into natural alignment then tightened everything up. | |||
Revision as of 01:35, 28 July 2018
Last revision 20180728013554 by Leebc
Accessing the Hypercube
- From within the Tampa Hackerspace network, the Hypercube #1 can be accessed by browsing to _____________
- Remotely, printer status can be viewed by logging in to THS's Slack and viewing the #3d_printer_status channel.
Building the Hypercube
Hypercube 300....and it uses CoreXY motion mechanics.
Problems we've encountered
Hypercube bed is all the way down and does not want to move
Resolution by @adrianm1972:
- The Z motors were a little out of alignment with the z lead screw nuts on the best. It ran fine at the top of its range because the lead screws are unsupported up there and that masks the alignment problem. At the bottom of its movement range everything is bolted to the frame and the slight misalignment cause binding that the Z stepper motors could not overcome.
- We brought the bed all the way down, loosened the Z motor mounts and let everything pull itself into natural alignment then tightened everything up.